SurfKoat Aqualon LP-120 is a premium quality, easy to use, lithium-potassium blend silicate concrete densifier, hardener and sealer used in the process of polishing concrete. Aqualon LP-120 creates a permanent dust-proof surface by reducing the porosity of the concrete and hardening the surface. Densifiers actually become a permanent part of the concrete itself, and will not peel, scratch or wear away due to heavy traffic. After application of Aqualon LP-120, a floor polisher can then be used to create a high-gloss finish.
Check out the "Help Center" above, send us an email or just give us a call and we'll be glad to help you with your order!
An excellent densifier for polishing!
No reviews yet for this product.
Aqualon LP-120 is a premium, fast acting, blended lithium potassium silicate densifier. Lithium-potassium silicates are easy to apply, penetrate deep, and react quickly to create a hard dense surface perfect for polishing. Lithium-potassium silicates also help to combat surface ASR.
Cleaning and Preparation Instructions
Do not apply to any surface that is dirty, frozen, or heavily saturated or flooded with water. Surface must be clean and free of all debris, dry, and absorbent. Mist water in a small area to test the surface for absorbency. Any surface to be treated should uniformly wet out. If the surface to be treated does not wet out uniformly, it is then recommended to prepare the surface mechanically to increase porosity and to remove any remaining surface contaminants.
We do not recommend application of any hardener or densifier to any concrete slab that has been cured less than 28 days.
All concrete surfaces should be clean and completely dry before application.
Basic application (if not polishing):
Apply at a rate of 600-800 sq. ft. per gallon using an industrial grade sprayer with a 0.5 gal./min. fan tip, lint free mop, or soft bristle push broom. Ensure floor saturation for 15-20 minutes, removing any puddle areas with a soft bristle push broom. Apply more Aqualon LP-120 to areas that appear to be more porous and are absorbing the material more. Rework any excess material with a soft bristle broom as to allow the material to dry evenly. Remove any excess or residue with a stiff bristle broom or dry pad floor buffer.
After completing the 400 grit stage of polishing, apply a saturating, uniform coat of Aqualon LP-120 at a rate of 400-600 sq. ft. per gallon using an industrial grade sprayer with a 0.5 gal./min. fan tip, lint free mop, or soft bristle push broom, ensuring floor saturation for 15-20 minutes. Do not allow to puddle. Allow to dry. Follow through with additional polishing steps until desired appearance is achieved. Additional applications of Aqualon LP-120 can be added at any stage before the final polishing phase is done if necessary at a rate of 600-800 sq. ft. per gallon. Allow to dry. Remove any excess residue with polishing diamonds or polishing pads. Flushing with water is not necessary. Note: For softer concrete an initial application of Aqualon LP-120 can be applied after the 80 grit stage prior to the standard polishing steps to achieve a harder surface.
Of course, having the right tools will make your job easier, so scroll to the bottom to see our recommended Sprayers, Brushes and Application Tools!
Coverage Rates: Coverage rates are approximate and will vary depending on substrate density, porosity and temperature. In most cases, 2-3 coats are required. Coverage rates based on total combined two coat application.
Troweled concrete: 200-400 sq. ft. / gallon